Drive Specification
| Motor Model | BT-42 series | BT-56 series | BT-86 series | |
|---|---|---|---|---|
| Input Voltage | 24VDC ±10% | 40 ~ 70VDC | ||
| Control Method | Bipolar PWM drive with 32bit MCU | |||
| Current Comsumption | Max 500mA (Except motor current) | |||
| Operating Condition | Ambient Temperature | · In Use: 0~50˚C · In Storage: -20~70˚C |
||
| Humidity | · In Use: 35~85% RH (Non-Condensing) · In Storage: 10~90% RH (Non-Condensing) |
|||
| Vib. Resist | 0.5g | |||
| Function | Resolution [ppr] | 500 1,000 1,600 2,000 3,200 3,600 4,000 5,000 6,400 8,000 10,000 20,000 25,000 36,000 40,000 50,000 (Selectable by parameter) * Default : 10,000 |
||
| Max. Input Pulse Frequency | 500kHz (Duty 50%) | |||
| Protection Functions | Over Current Error, Over Speed Error, Step Out Error, Over Temperature Error, Over Regenerated Voltage Error, Motor Connect Error, Motor Voltage Error, System Error, ROM Error | |||
| LED Display | Power status(Green), Alarm status(Red) | |||
| STOP Current | 10%~100% (Selectable by parameter) Be setted to set value of STOP Current after 0.1 second after motor stop. * Default : 50% | |||
| Pulse Input Method | Pulse / 2 Pulse (Selectable by parameter) 1 Pulse: Pulse/Direction, 2 Pulse: CW/CCW * Default : 2 Pulse |
|||
| Rotational Direction | CW/CCW (Selectable by parameter) Used when changing the direction of motor rotate * Default : CW |
|||
| Speed/Position Control Command | Pulse Train Input (Photocoupler Input) | |||
| I/O Signal | Input Signal | Motor Free / Alarm Reset (Photocoupler Input) | ||
| Output Signal | Alarm, Run/Stop (Photocoupler Output) | |||
- * 1 : Up to the resolution of 10,000[ppr], maximum speed can be reached by 3,000[rpm] and with the resolution more than 10,000[ppr], maximum speed shall be reduced accordingly.
System Configuration
Ezi-STEP BT
External Wiring Diagram
Ezi-STEP-BT-42, 56mm
* Alarm Reset signal line is also used of r Motor Free signal.(For details, please refer to Control Signal Input/Output Description)
* When connects I/O cable between controller and drive, please turn off the power of both controller and drive, in order to protect the drive from any damage.
Ezi-STEP-BT-86mm
* Alarm Reset signal line is also used of r Motor Free signal.(For details, please refer to Control Signal Input/Output Description)
* When connects I/O cable between controller and drive, please turn off the power of both controller and drive, in order to protect the drive from any damage.