Drive Specification
| Motor Model | EzM2-20-F series | EzM2-28-D series | EzM2-35-D series | EzM2-42-A series | EzM2-56-A series | EzM2-60-A series | |
|---|---|---|---|---|---|---|---|
| Drive Model | EzS2-EC-MI-20 series | EzS2-EC-MI-28 series | EzS2-EC-MI-35 series | EzS2-EC-MI-42 series | EzS2-EC-MI-56 series | EzS2-EC-MI-60 series | |
| Input Voltage | 24VDC ±10% | ||||||
| Control Method | Closed loop control with 32bit MCU | ||||||
| Current Comsumption | Max 500mA (Except motor current) | ||||||
| Operating Condition | Ambient Temperature | · In Use: 0~50˚C · In Storage: -20~70˚C |
|||||
| Humidity | · In Use: 35~85% RH (Non-Condensing) · In Storage: 10~90% RH (Non-Condensing) |
||||||
| Vib. Resist | 0.5g | ||||||
| Function | Rotation Speed | 0~3,000 [rpm]*1 | |||||
| Resolution [ppr] |
4,000/Rev. Encoder model: 500 1,000 1,600 2,000 3,600 5,000 6,400 7,200 10,000 4,000 10,000/Rev. Encoder model: 500 1,000 1,600 2,000 3,600 5,000 6,400 7,200 10,000 16,000/Rev. Encoder model: 500 1,000 1,600 2,000 3,600 5,000 6,400 7,200 10,000 16,000 20,000/Rev. Encoder model: 500 1,000 1,600 2,000 3,600 5,000 6,400 7,200 10,000 20,000 (Selectable by parameter) |
||||||
| Protection Functions | Over Current Error, Over Speed Error, Position Tracking Error, Over Load Error, Over Temperature Error, Over Regenerated Voltage Error, Motor Connect Error, Encoder Connect Error, In-Position Error, ROM Error, Position Overflow Error | ||||||
| EtherCAT | Supported Protocol | CoE (CiA 402 Drive Profile), FoE (Firmware Download) | |||||
| Supported Mode | Profile Position Mode, Homing Mode, Cyclic Synchronous Position Mode | ||||||
| Synchronization | Free Run, SM Event, DC SYNC Event | ||||||
| I/O Signal | Input Signal | 3 dedicated inputs (LIMIT+, LIMIT-, ORIGIN), 3 user inputs (Photocoupler Input) | |||||
| Output Signal | 2 user outputs (Photocoupler Output), Brake | ||||||
- * 1 : Up to the resolution of 10,000[ppr], maximum speed can be reached by 3,000[rpm] and with the resolution more than 10,000[ppr], maximum speed shall be reduced accordingly.
- * 2 : When selected resolution is more than encoder resolution, motor shall be operated by microstep between pulses.
- * 3 : The EzS2-EC-MI-56, 60 series are needed to be mounted on an external heat sink or a structure capable of dissipating heat.
System Configuration
Ezi-SERVO EtherCAT MINI
External Wiring Diagram
Ezi-SERVO EtherCAT MINI
[CAUTION] Please refer to the Manual when connects motor extension cable. Careful connection will be required to protect the drive from any damages.
※ When connects I/O cable between controller and drive, please turn off the power of both controller and drive, in order to protect the drive from any damage.