Home Sensor Set
1. Type
| Part Number | Sensor output | Applicable products |
|---|---|---|
| E2S-W23 | NPN | VZR-28, VZR-42 |
| E2S-W25 | PNP |
2. Components(E2S-W23)
3. Specifications
| Category | NPN Type | PNP Type |
|---|---|---|
| Sensor Part Number | E2S-W23 (OMRON product) | E2S-W25(OMRON product) |
| 전원 전압 | DC 12 ~ 24 V ±10 % Ripple(P-P) 10 % or less | DC 12 ~ 24 V ±10 % Ripple(P-P) 10 % or less |
| Current Consumption | 13 mA or less | 13 mA or less |
| Control Output | NPNOpen Collector Output DC 12 ~ 24 V 50 mA or less Residual voltage 1 V or less(at 50 mA load current) |
PNPOpen Collector Output DC 12 ~ 24 V 50 mA or less Residual voltage 1 V or less(at 50 mA load current) |
| Indicator LED | Detection Display (Red) | Detection Display (Red) |
| Sensor Logic | Normally Open | Normally Open |
4. Precautions for Limit Sensor Set Installation
- • Use the limit sensor set in environments where the installation surface temperature does not exceed 55°C.
- • Do not install the limit sensor while power is applied, as this may cause injury or equipment damage.
- • After exposure to vibration or impact, check the sensor to ensure it remains properly mounted and functional.
- • Accumulated dust on the sensor may cause malfunctions. Regular cleaning or replacement is recommended.
Home Sensor Cable Installation
1. NPN Type
• With User’s Controller
- The power voltage for the sensor can be DC 12 ~ 24 V and the signal current for the sensor can be up to 50 mA. For details, refer to the controller specifications for wiring. If the sensor's signal current exceeds the current range of the controller or sensor, connect a current limiting resistor (R).
• With Embedded Motion Controller Type Products (e.g., Ezi-SERVO II Plus-E)
2. PNP Type
• With User’s Controller
- The power voltage for the sensor can be DC 12 ~ 24 V and the signal current for the sensor can be up to 50 mA. For details, refer to the controller specifications for wiring. If the sensor's signal current exceeds the current range of the controller or sensor, connect a current limiting resistor (R).
• With Embedded Motion Controller Type Products (e.g., Ezi-SERVO II Plus-E)
